Software - Latest Version 2014 Revision 2 circuit board with UK circuit modifications and upgrade for full compatibility (see note below about circuitry mods), note the difference in the Revision 2 casing design, this version is designed from the ground up to be a USB device, V1 Op-com was based on older Serial Port hardware with additional electronics to use the USB bus, dedicated USB. Extract file to the desired destination e.g C:OPCOM; Plug in the opcom unit; Open Device Manager (Press the Windows key + X or right-click on Start to open the Power User Menu.) Find opcom USB V2 then right-click and select update driver; Locate the extracted OPCOM folder from earlier and highlight the folder drivers 32 & 64bit then click next.
It’s verified that only OPCOM OP-COM firmware version 1.39 running with VAUX-COM 2009 software can read security codes for key programming, all tested by users.
Hunta says in http://www.corsa-c.co.uk/forum/
“opcom 1.39 has always worked for me reading security codes and for programming”
Marks152 says: Intel graphics media accelerator (gma) 3600 driver windows 10 pro.
“1.39 is the ONLY firmware you should be running when using 100219a. It is designed to run with this software and is the ONLY version that will allow FULL use of the interface. Any firmware higher will restrict access to the instruments.”
Ssmith73 says:
“1.39 firmware can get a spare key fob programmed”
x-paul-x06 says in http://www.vauxhallownersnetwork.co.uk/
Download matlab 2018a full crack. “opcom will read his security code but it should as i managed to down grade the firmware to 1.39”
Where to get old version OPCOM?
Opcom firmware v1.39 (not OPCOM V1.59)
VAUX-COM 100219a
Note: opcom fw: v1.39 with 2009 software is the only version to read security codes
Why you need security codes?
For programming new keys and immoboliser, functions the Security Code is required. This code can normally be found on the Pass. Unfortunately, the Car Pass is often lost.
What models can be read security codes?
With OP-COM you can read the security code from the following models:
Corsa-C Meriva Tigra-B
How to read security codes with OPCOM v1.39?
Choose Body
Opcom Activation Key Office 2016
Choose Instrument
Choose EPROM info
Now the Security Code can be read from EPROM
How to use OPCOM 2009 software to program keys?
Opcom: Year -> vehicle -> body -> Cim -> Programming -> immo-programming -> security-code -> add new key
Immo
Security code
vProgram key
Opcom firmware 1.39 can read security codes. but unluckily, it stops production.
you can use Carprog 8.21 to read pin like dimitar, and then program keys with opcom 1.59
Opcom Activation Key Generator
who like this article also viewed: